1 x Rebuilt Allison 501KB5 3MW Gas Turbine Mobile Genset
The Unit’s Aluminum Skin Is In Very Good Condition. It Has Been Cleaned And Can Be Painted To Buyer’s Preferences
Supplier. has completed the overhaul and load testing of a 3750 KVA (3MW) Mobile Generator Set to as-new condition with new PLC controls. The unit incorporates all the major components including intake and exhaust silencing and ducting into a single footprint with no additional peripheral attachments necessary. This unit served as standby power for the city of Fort Nelson, BC. The unit is Black Start and can be configured to run on either Natural Gas or Liquid fuels. It can be configured to 2400/4160 VAC 4 wire Wye Bus or 2400VAC 3 wire Delta.
***Unit is presently Gas. Can be delivered as Diesel at no additional cost
SPECIFICATIONS
Dimensions:
Length:42 Ft
Width: 10 Ft
Height: 12 Ft – 10 In
Weight: Rear
Axles: 42,000 lbs
Fifth Wheel: 33,000 lbs
Total: 75,000
lbs (weights approximate until scaled)
Engine: Allison Model 501KB5 Gas Turbine
Horsepower: 4800
Hp (maximum rated)
Time since overhaul: 0
Starter: FS100 Gas Turbine c/w 24VDC electric starter
Gearbox:
Make: Falk
Ratio: 7.684:1
Generator:
Make: Electric
Motor Frame 9000
Serial : 173185611
RPM: 1800
Rated KVA: 3750
Volts: 2400/4160
Amps: 900/521
Phase: 3
Cycles: 60Hz
Hours since new: 23,000
Refurbished: 1988
(Beaver Electrical Machinery, Vancouver, BC)
Hours since refurbish: <1000 Inspected and tested: 2007 (Beaver Electrical Machinery)
Controls (NEW): PLC: Allen Bradley
ControLOGIX PLC and HMI programming:
Fuel Control NG: Optional Continental Controls Model AGV1O or Woodward
Fuel Control Diesel: OEM Woodward Generator Protection Relays: GE
AutoSync: Basler
Control Power (NEW): 12OVAC
Battery Charger: Philtek
Model PCVF
Inverter: Philtek
Model PIV 750-120-N
Batteries: Magnacharge
Model 27TMX 12VDC 1O5AH (10 Hr)
Trailer:
Year and Make: 1974 Willock
Rebuilt: 2007 (all new brakes, drums, bearings
Supplier had all the existing protection relays tested and all are within specification. It was deemed prudent to offer the unit with these existing and calibrated components as a lower cost option. Should the client wish the total upgrade of the protection and control, we will upgrade as requested.